GMC Truck Hesitation TBI problems
GMC Truck Hesitation TBI problems
1991 GMC 1500, TBI 350, 700r4 trans, 4wd. Replaced plugs,wires,cap,button,ignition coil, and pcv valve less than 4 months ago to get rid of hesitation and stumble. Now, the problem is back and is worse than it was before. i have heard that an egr valve may be the problem. do you have any ideas of where to start or how to diagnose the problem?
Re: GMC Truck Hesitation TBI problems
Ya, could be an EGR problem.
Remove it, blow out the passages and the the valve. Then take for a drive to see if that helped. Also use a vacuum pump to see if it actually moves.
Being 20 years old, may be full of carbon.
Remove it, blow out the passages and the the valve. Then take for a drive to see if that helped. Also use a vacuum pump to see if it actually moves.
Being 20 years old, may be full of carbon.
Re: GMC Truck Hesitation TBI problems
Get your fingers under the egr valve. Rev the engine a few times to feel if the diaphram moves. If it seems to be irratic, try unplugging the vaccum hose. If it still moves with the engine speed, the valve is bad. That is because it should not operate with the vacuum hose off.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 4 Replies
- 19306 Views
-
Last post by carriedi
Thu Nov 30, 2017 1:10 pm
-
- 1 Replies
- 10481 Views
-
Last post by carriedi
Fri Mar 18, 2016 10:46 am
-
- 3 Replies
- 5720 Views
-
Last post by carriedi
Sun May 14, 2017 7:07 pm
-
- 1 Replies
- 3281 Views
-
Last post by carriedi
Wed Sep 02, 2015 10:33 am
-
- 1 Replies
- 7711 Views
-
Last post by carriedi
Sat Oct 03, 2015 10:23 am