Quantcast




All times are UTC - 6 hours [ DST ]




Ask A Question Reply    Go to page 1, 2  Next
Author Message
 

contributions: 1
Is there a common link between the turn signals, cruise control and trip computer? A few weeks ago they started sporadically working. When one was not working neither were the others and if one was working they all were. I would set the cruise control and after some time it would shut down. I noticed that the trip computer was not on and also the turn signals did not work. At first it was once in a while and they would come back on. Eventually they all three quit working. I have been through every fuse in the fuse panel below the steering wheel and they are all good. I have not noticed anything else that is not functioning properly.


Share on FacebookShare on DiggShare on DeliciousShare on TechnoratiShare on TumblrShare on Google+
   
Reply with quote  
* Search   
 
User avatar

contributions: 1903
Images: 37
Location: Oregon
check the fuse #18 in the left side of the dash. it powers up the turn and brake light. if the fuse has battery voltage with the key on then check the light green and red wire that goes to your brake pedal switch. If the wire doesn't have battery voltage with the key on that will turn off the cruise and the turn signals. I don't know if that is connected to the trip though.


   
Reply with quote  
 
carriedi wrote:
> check the fuse #18 in the left side of the dash. it powers up the turn and brake
> light. if the fuse has battery voltage with the key on then check the light green
> and red wire that goes to your brake pedal switch. If the wire doesn't have battery
> voltage with the key on that will turn off the cruise and the turn signals. I don't
> know if that is connected to the trip though.

Would this be the same for a 2002 ford ranger? The light green and red wire?


   
Reply with quote  
 
User avatar

contributions: 1903
Images: 37
Location: Oregon
the light green and red wire is the same color code as the pick up but it comes from fuse #13 a 20A fuse in the fuse box under the left side of the dash. That light green and red wire goes from the fuse to the brake pedal switch. It comes out of the brake switch as a light green wire.

that may or may now help you depending on what your problem is.


   
Reply with quote  
 
carriedi wrote:
> the light green and red wire is the same color code as the pick up but it
> comes from fuse #13 a 20A fuse in the fuse box under the left side of the
> dash. That light green and red wire goes from the fuse to the brake pedal
> switch. It comes out of the brake switch as a light green wire.
>
> that may or may now help you depending on what your problem is.

Same problem with no blinkers or cruise control. Thank you very much! Will see if it is the problem this weekend.


   
Reply with quote  
 
User avatar

contributions: 1903
Images: 37
Location: Oregon
you should look at your brake switch. the cruise uses different wires going through the brake switch. Cruise uses fuse #9 in the fuse box under the left side of the dash. It has a brown wire that goes to the 3# pin on your brake switch. It comes out of the brake switch on a red and light green wire that then goes to shift interlock, the clutch switch, clutch triple switch jumper then becomes a ran and light blue that goes to your cruise speed control module. So, even though the wires are separate (turn and cruise) they both use the brake switch. So, check the switch out


   
Reply with quote  
 
carriedi wrote:
> you should look at your brake switch. the cruise uses different wires
> going through the brake switch. Cruise uses fuse #9 in the fuse box under
> the left side of the dash. It has a brown wire that goes to the 3# pin on
> your brake switch. It comes out of the brake switch on a red and light
> green wire that then goes to shift interlock, the clutch switch, clutch
> triple switch jumper then becomes a ran and light blue that goes to your
> cruise speed control module. So, even though the wires are separate (turn
> and cruise) they both use the brake switch. So, check the switch out

Thank you!! I will let you know what I find, hopefully sometime this weekend when the humidity goes down.


   
Reply with quote  
 

contributions: 2
after engine warms up cc will not engage


   
Reply with quote  
Ask A Question Reply    Go to page 1, 2  Next


   Similar Topics   Author   Replies   Views   Most Recent 
New Articles View the first 1999 f250

in Ford Trucks

bubba189

1

1058

Mon Nov 17, 2014 9:22 pm

carriedi View the latest

New Articles View the first Speedometer not working on my 2000 Ford F250 super duty five

in Ford Trucks

Testercst

1

1249

Wed Sep 30, 2015 5:06 pm

carriedi View the latest

New Articles View the first f250 5.4 starts then stall no fuel , changed most fuel parts

in Ford Trucks

milkmandelight

4

823

Sun Nov 13, 2016 12:09 am

Rachel View the latest

New Articles View the first 2003 Ford Windstar Misfires Under Load

in Ford Trucks

davlor2

1

1257

Thu Jan 30, 2014 6:00 pm

carriedi View the latest

New Articles View the first 2003 Ford Mustang Base 6 cyl model

in Ford Cars

lilbit221959

1

1527

Fri Oct 17, 2014 12:00 am

carriedi View the latest

New Articles View the first 2003 CHEVY SILVERADRO 5.3 T ENGINE WON'T START

in Ford Trucks

ronnie310

4

394

Fri Jul 08, 2016 12:01 am

carriedi View the latest


All times are UTC - 6 hours [ DST ]



Search for:
Jump to:  
Contact Us