Help need my baby back on the road plz help

Ask our auto mechanics for help to all your GMC truck questions.
Txbigboi
Posts: 1
Joined: Mon Mar 03, 2014 10:50 pm

Help need my baby back on the road plz help

Unread post by Txbigboi » Mon Mar 03, 2014 11:34 pm

Put 96 gmc 350 tbi into my 93 gmc went from v6 to the v8 changed out cam to milling #m1103 & lifters now she startd runs and drives but when gets to lowest rpm or to a good idle it just shuts off but will start right back up will tun again then will idle back down and die no way to adjust the idle on the throttle body now I am lost and bout to loos my job if I cant get this fixed need my truck for wrk right now

User avatar
carriedi
Posts: 2573
Joined: Wed Apr 10, 2013 12:42 pm

Re: Help need my baby back on the road plz help

Unread post by carriedi » Tue Mar 04, 2014 8:53 pm

did you change everything that goes with the V8 motor... ECM and stuff?
Browse "SIMILAR TOPICS" At The Bottom Of This Page.

User avatar
carriedi
Posts: 2573
Joined: Wed Apr 10, 2013 12:42 pm

Re: Help need my baby back on the road plz help

Unread post by carriedi » Thu Mar 06, 2014 11:45 am

you can take out the idle adjust tamper cover and adjust the idle stop. the shiney silver cover close to the throttle shaft, in the picture, is covering the idle stop adjuster. If you look at where your throttle stop is, the opposite side side of the stop that sticks out of the throttle body has a cover put in the throttle body so that it can't be tampered with. However this cover can be removed and you can adjust the idle stop. If your idle is too low for your conversion.
Browse "SIMILAR TOPICS" At The Bottom Of This Page.

  • Similar Topics
    Replies
    Views
    Last post