Won't start after replacing balancer
Won't start after replacing balancer
I have a 1990 olds delta 88 , and the car ran perfect before replacing the harmonic balancer, Now it won't start, cranks just fine.
Re: Won't start after replacing balancer
you should check your cam and crank sensors to make sure they are okay with your replacement balancer.
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
Re: Won't start after replacing balancer
Ordered crank cam sensor. Old one looked fine????? Was careful . Still not sure, but thanks.
Re: Won't start after replacing balancer
If you can get a scanner and crank the engine over, you should be able to get an rpm reading from the crank sensor. Do you have the correct balancer? Do you see the part of the balancer that allows for the signals for crank sensor.
Browse "SIMILAR TOPICS" At The Bottom Of This Page.
-
- Posts: 1
- Joined: Wed Feb 04, 2015 11:48 am
Re: Won't start after replacing balancer
you have to relearn the crankshaft position sensor with an scan tool
-
- Similar Topics
- Replies
- Views
- Last post
-
-
New post replacing all brake lines on 2005 rendezvous awd
by Johana » Tue Dec 07, 2021 9:11 pm » in Buick - 1 Replies
- 11994 Views
-
Last post by carriedi
Thu Dec 09, 2021 11:19 am
-
-
- 1 Replies
- 11018 Views
-
Last post by carriedi
Fri Aug 27, 2021 4:46 pm
-
- 1 Replies
- 12298 Views
-
Last post by carriedi
Sat Aug 19, 2017 6:29 pm
-
- 3 Replies
- 9303 Views
-
Last post by carriedi
Thu Dec 08, 2016 10:34 pm