For several months now, the ABS and Brake Warning Lights have been on constantly. The car drives fine. The car was checked for ABS codes and no codes were found. The brake fluid level is good and the front and rear pads/shoes are relatively new
you had it scanned and showed no codes, did you drive it and watch the data stream? did you use a tech2? The master cylinder is full but did it go low and someone filled it back up? Is the float stuck? (check the pink and black wire going to the master fluid level switch) did you check all your fuses? the ABS 40amp and the ABS 30amp fuse out in the underhood fuse box? or the ERLS fuse in the fuse panel?